Home

What Common Mistakes Do Learner Drivers Make?

Common learner driver mistakes include poor observation, an incorrect seating position, following other vehicles too closely, rushed decisions and inconsistent pedal control. You can correct these habits by practising each skill separately with your instructor, then combining them as your control and judgement improve.

Not adjusting your driving position

If you sit too far from the pedals, you may struggle to press the brake firmly or press the clutch all the way down. Sitting too close restricts your steering movement. Adjust your seat so you can press the pedals fully without stretching and hold the steering wheel with your elbows slightly bent.

Set your mirrors after adjusting your seat, not before. Your interior mirror should give you a clear view through the rear windscreen, while your door mirrors should show the road beside and behind the car.

  • Adjust your seat and head restraint before moving off.
  • Check that you can reach the pedals and controls comfortably.
  • Set your mirrors from your normal sitting position.
  • Fasten your seat belt and check that your passengers have fastened theirs.
  • Check which gear you've selected and whether the parking brake is on before starting the engine or moving off.

Ask your instructor to explain any unfamiliar controls before you need them. Looking down to find the demister control or indicator stalk while driving takes your attention away from the road.

Looking only at the road directly ahead

If you stare at the bonnet or the vehicle immediately ahead, you leave yourself little time to respond. Look further along the road, then regularly check the road closer to you, your mirrors and either side. Watch for pedestrians near parked cars, opening doors, brake lights and vehicles approaching junctions.

Mirrors have blind spots, so a mirror check alone may not reveal a vehicle beside you. Before moving off or changing position, check the relevant mirrors and your blind spots as appropriate, without looking away from the road ahead for too long. The Highway Code explains what to check before moving off and manoeuvring.

Don't check your mirrors out of habit without noticing what's there. Use what you see to decide whether to wait, slow down or maintain your position. If your instructor repeatedly spots hazards before you do, practise briefly describing developing hazards aloud when they ask you to.

Driving at an unsafe speed

A speed limit is a maximum, not a target you must reach. Reduce your speed when you can't see far ahead, you have limited space or pedestrians could enter your path. Equally, avoid driving unnecessarily slowly on a clear road simply because you haven't planned what to do next.

Leave enough stopping space between your car and the vehicle ahead. In moving traffic on a dry road, the Highway Code recommends a gap of at least two seconds on faster roads, with a larger gap when conditions reduce grip or visibility. Treat this as a minimum, not a guarantee that you can stop safely.

Ease off the accelerator early when you see a queue or obstruction, rather than waiting and braking sharply. Check your mirrors before slowing down when you have time, but never delay necessary braking to complete a mirror check.

Poor pedal control

In a manual car, you can stall the engine if you release the clutch too quickly or don't press the accelerator enough. Practise finding the biting point, where the clutch starts transmitting power, and coordinate the pedals as your instructor demonstrates. How much you need to press each pedal depends on the car, gradient and load.

Avoid riding the clutch, which means keeping unnecessary pressure on the pedal while driving. Once you've changed gear, take your foot off the clutch pedal. On an incline, use the brake or parking brake as appropriate rather than holding the car still by slipping the clutch.

Don't look down at the gear lever. Practise finding each gear while safely parked, with the engine off and your instructor's guidance. Select a gear that suits your speed rather than following a fixed speed-to-gear chart.

In an automatic car, use your right foot for both the accelerator and brake during normal learner training. Before selecting drive or reverse, stop fully, keep the brake pressed and check your surroundings.

Rushing decisions in traffic

If you approach a junction too quickly, you may end up trying to brake, change gear, check for traffic and steer all at once. Read signs and road markings early, reduce your speed in good time and be ready to stop if you can't see clearly or traffic requires it.

A signal does not give you priority. Before changing lanes, check the available space and the speed of approaching vehicles, signal in good time and move only when it's safe. Don't assume another driver will slow down to let you in.

At junctions, never follow the vehicle ahead without checking for yourself. A gap suitable for that driver may have closed by the time you reach it. If you miss a turn or can't change lanes safely, continue safely and let your instructor suggest another route.

Rushing manoeuvres under pressure

During parking and reversing, you may focus on one mirror or reference point and forget to check around the rest of the car. Move slowly enough to stop promptly, keep checking all around throughout the manoeuvre and watch the front of the car as it swings out.

Use reference points as learning aids, not fixed rules for every vehicle. Your seating position, the car's dimensions and the available space affect when you need to steer. Stop and check again if you're unsure how much clearance you have. Don't keep moving and hope the car fits.

After a stall, missed gear or poor parking attempt, make the situation safe before trying again. Brake and secure the car as needed, then follow your instructor's guidance. Don't restart or move hurriedly because someone behind you sounds the horn.

At the end of each lesson, ask your instructor which mistake to work on first and how you'll know you've corrected it. Practise that specific skill under supervision rather than repeating the whole exercise without understanding what went wrong.

Sources